Some Precautions For Edge Banding Machine

The main advantages of the curved line edge banding machine are firm bonding, fast, light, and high efficiency. Factors such as the working environment and operating methods. Pay attention to the width, thickness, material, toughness, surface treatment and other factors when choosing the edge banding. Hot melt adhesives should pay attention to the difference between high, medium and low temperature adhesives, match the type of edge banding, and scientifically set the heating control temperature and the fluidity and solidification delay of the sol. The selection of the base material also has the quality, temperature, parallelism and perpendicularity requirements of the cut surface. The indoor temperature and dust concentration of the working environment also need to be considered. The base material, edge banding, and rubber shaft running speed, pressure, balance, Coherence and so on will affect the edge banding effect. 4. The method of repairing the curved and straight edge banding machine There will be some problems and failures in the use of the curved and straight edge banding machine. The common failures are:
1. Electrical failure. Including host stop, slow heating, program disorder, etc. If not eliminated in time, the motor and heating tube will be burned out, and even the entire mechanical system will be damaged. Mainly check the electrical control box, motor, heating tube, delayer, etc. during maintenance. This kind of overhaul generally needs to be repaired by professionals or by the manufacturer.
2. Gas circuit failure. Including air valve failure, air leakage, low air pressure, cutter and feeding failure, etc., mainly check the integrity of various pneumatic components, and replace parts can be carried out under the guidance of the technical personnel of the manufacturer.
3. Mechanical failure. Mainly include transmission failure, uneven glue coating, feeding failure and cutter failure, etc., mainly check the integrity and firmness of each mechanical part, and whether the transmission part is offset.
4. Bonding failure. Such as sticking, deviation, entrainment, etc., this is a comprehensive failure, which is related to the rubber shaft, edge banding, sol, substrate and operation. This kind of fault may appear alternately, or may appear singly, and the specific maintenance depends on the situation.